Cisco Catalyst 2960-x Series Doesn't turn on

[mmamed657]

Good day everyone! I have a problem with my Cisco Catalyst 2960-x Series switch. It does not show any signs of life, only SYST is lit, and STAT, SPEED, STACK are blinking. What to do? How to solve this problem? I can't understand...
I hope you can help me)

Sincerely, Mamed

[Flavio Miranda]

@mmamed657 

 Did you try to power off the switch, press the mode button, power on the switch and hold the mode button for 20 seconds or until SYS led goes solid and release mode button?

[mmamed657]

Yes, I tried to do this, but unfortunately it doesn’t help. The STAT, SPEED, STACK indicators flash 3 times and go out and then flash again 3 times and this process is repeated again and again

[Flavio Miranda]

What do you get on the console?

[balaji.bandi]

Connect the console cable and post complete boot logs here :

check LED means :

https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst2960x/hardware/installation/guide/b_c2960x_hig/b_c2960x_hig_chapter_01.html#ID277

[marce1000]

  - Attach a console , and check if any output can be seen on it after a power cycle ,

 M.

[mmamed657]

Thank you all very much) I found a solution, such a topic already exists, and I realized that it is useless to discuss it here.

This person in the discussion has the same thing as me with the switch   

[mmamed657]

More precisely, the discussions had the same topic and problem as mine. That topic of discussion is called:

Switch WS-C2960X-24PS-IN Blinking Lights

There everything was decided by sending the switch to a service center to service the equipment and replace spare parts, since I myself cannot repair or replace anything on the switch, I am of course upset. And I am grateful to you for your responsiveness and full support.

Sincerely, Mamed