03-08-2011 07:12 PM - edited 03-06-2019 03:58 PM
Okay guys,
I managed to get a 4006 at an auction that used to belong to a school real cheap
It came fully populated with fast ethernet modules. So I Thought that this would be nice for my home lab.
The only problem is that I can't log into the switch. I have tried everything in my googling powers and can not find a solution.
I would like to reset it to defaults with no passwords required.
Help is appreciated
03-08-2011 08:43 PM
What supervisor engine do you have?
03-08-2011 09:54 PM
Supervisor Module II
03-09-2011 12:06 AM
03-09-2011 04:05 AM
Did it work?
03-09-2011 07:33 AM
Thanks for the info.
When I typed confreg I received not a rocognized command message.
When looking around romon mode, I removed al NVRAM settings and performed the password recovery procedure using blank passwords.
This seemed to work to where I can get in now.
Could anyone point me to a guide on basic setup for this?
03-09-2011 08:32 AM
Not sure if you already check this.
http://www.cisco.com/en/US/products/hw/switches/ps663/ps668/index.html
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: