Default Gateway On SG300 Switch

[Ross Beer]

I'm having a problem setting the 'default gateway' on an SG300 switch, every time I set it I get an error saying that the gateway needs to be directly connected to the device.

I can't connect the gateway directly to the device as it's the other side of an ASA firewall, is there anyway I can get around this?

[tj.mitchell]

The gateway should be L2 adjacent from the device so that it's on the same VLAN as the switch.

Switch is on VLAN10

Gateway is on VLAN10

Could be a few hops away through trunk interfaces, but still L2 adjacent.

Make Sense??

[Ross Beer]

Ok, the switch doesn't currently use VLAN's and therefore has the default VLAN1 for management and all other devices.

Could this be a bug in the web interface? I though it was odd as every other device on the network is configured in the same way.