12-26-2018 02:15 AM - edited 03-08-2019 04:53 PM
Hello,
I am using CiscovL2 for studying QoS. I am able to install the image in GNS3 successfully. But when I open the console the CLI does not appear. The attached snapshot gives a better idea. Any help regarding this will be appreciated. Thanks in advance.
01-17-2019 07:33 AM - edited 01-17-2019 07:36 AM
I guess you followed this document ?
did you power on the appliance ? right click on the appliance and click Start
01-17-2019 07:38 AM
Yes, I have followed the same document. Even after powering the appliances the CLI does not appear.
01-17-2019 07:53 AM
your image does not look like the GNS3 console
do you right click and select console?
01-17-2019 08:09 AM
Yes, I have done right click and opened the console. I running GNS3 on Linux that's why the console looks different.
01-17-2019 08:21 AM
Hello,
can you post a screenshot of the GNS3 terminal settings you are using ?
01-17-2019 08:26 PM
05-18-2020 02:51 PM
What fixed this for you? I haven't seen any fix actions below and I'm having the same problem.
05-19-2020 07:24 AM
you better post this as a new thread (the current is more than a year old)
- describe what is happening and what not, not just "same problem"
- did you power on the device?
be patient it may take some time before output appears when the "device" is booting.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide