11-10-2021 10:09 AM
Hello,
I want to reset to factory defaults a Cisco ME-3400E because I don't know the password.
I tried to connect with serial using console cable but got nothing with Putty and SecureCRT (baud 9600, bits 8, flow control xon/xoff)
I have used Ctrl+Break, Alt+Break, Shift+Break, Ctrl+Alt+Break, Ctrl+Shift+Break, Alt+Shift+Break, Ctrl+Alt+Shift+Break but the device Cisco is not detecting the break sequence.
Have you any other combinations i can use for sending Break Sequence to my device ?
Thak you help
11-10-2021 01:43 PM
Hello,
tough one. Somebody before you might have changed some settings such as the baud rate, so you might want to try different ones.
Also, you could try any of the below alternatives to Putty and SecureCRT:
https://www.netadmintools.com/best-putty-alternatives#wbounce-modal
11-10-2021 11:54 PM
Hello Georg,
I'll try. I keep you informed
Thank you
11-15-2021 01:12 AM
Hello,
I tried with these tools. it does not work
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide