06-19-2023 03:23 AM
Hello,
We would like to implement Q-in-Q with LACP tunneling in Cisco Nexus 9372PX but the option is not available in the command line.
Does Cisco Nexus 9000 Series support this feature?
what is the recomended models of Cisco Nexus 9000 Series that support this feature (LACP tunneling) ?
Models should have 48p 1/10G SFP+ and 40G uplinks.
Thanks.
06-19-2023 03:30 AM
According of this guide l2 protocol lacp us support in qinq of nexus 9000
06-19-2023 01:21 PM
Hi, Thanks for your reply.
"9000" is a Series, in fact our current model 9372PX not supported this feature.
It will be helpful if some one know specific model that support this feature (in 9000 Series).
Thanks.
06-19-2023 01:24 PM
This chapter describes how to configure IEEE 802.1Q-in-Q VLAN tunnels and Layer 2 protocol tunneling on Cisco NX-OS devices (7.0(3)F3(4), 7.0(3)I2(1) and later).
06-19-2023 10:31 PM
the command "switch(config-if)# l2protocol tunnel LACP" is not available in our model 9372PX (Version 9.3(10)).
attached picture
06-19-2023 10:33 PM
Did you enable lacp feature?
06-19-2023 11:56 PM
yes
# sh feature | i enable
bfd 1 enabled
icam 1 enabled
lacp 1 enabled
lldp 1 enabled
sshServer 1 enabled
tacacs 1 enabled
telnetServer 1 enabled
06-20-2023 05:02 AM
Open TAC there is no way to know this feature support in this platform or not.
Thanks
MHM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide