04-01-2011 09:54 AM - edited 03-06-2019 04:23 PM
Dear Sir,
Find the attached image.
I want to connect router0 with router1 and want them to work as brigdes , the routers in diffirent places and they are connected through Ethernet extender modems ( modems connected with each othere by a pair copper line - dead line)
I made test and connect them by UTP cable as showm in the image and do the written configuration but PC1 can't ping to PC0 and vice versa.
Do you think the configuration is not right or what?
Note: Just I used the Packet Tracer program to draw the topology not to make test. I did test by physical routers.
Regrads
04-01-2011 03:04 PM
Hi,
In addition to these command, you also need to create a BVI interface interface and give it an IP address. See below example
bridge irb
interface BVI1
ip address 192.168.0.3 255.255.255.0
HTH
Reza
04-02-2011 12:02 PM
Thanks Reza,
I did which you said so see the attached configuration for the two routers.
I made the test using cisco router 837 and using E0 and E2 interfaces.
PC1 connected to RTR1 (E0)
PC2 Connected to RTR2 (E0)
RTR1 Connected with RTR2 through E2 in each of them.
After I completed:
PC1 and PC2 can ping to BVI 1 in RTR1 and BVI1 in RTR2 but they can't ping to each other.
WHat do you think the problem ?
04-02-2011 01:52 PM
After looking at your config, I do not see below command in RTR1
bridge 1 protocol ieee
Can you add this and test again?
HTH
Reza
04-06-2011 02:04 PM
Sorry for lateness,
bridge 1 protocol ieee is available in both routers.
regards.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide