Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear All,I have a prolem in a router 1841 so I cahnged the flash and the RAM but the problem still appear, every time go to rommon!! I changed the registry to default ( 0x2102 ) and problem still appear !!I went to cookie and make sure from the HEX n...
Dear all, We have a cisco router 2811 so it has 2 IOS one is default IP- base and the other is c2800nm-ipbasek9-mz.124-20.T1 to support the E1-PRI card.The router working fine then anfter 2-5 hours the service go down and after we access by Hyper te...
Dear Sir,There is many cisco products, so sometime I don't know for what this product use? Does Cisco has a link in its website explain for example:- Cisco router 1841 used for connecting more than one network and do NAT funtion see the diagram below...
Dear Sirs,I have an E1 (PRI) in the main office for a certain company so there are 25 branch belong to this company.I want to know what I need of the HW and configuration to let the branches call the main office through this E1 and the cost will be c...
Dear Sirs,as shown in the attached diagram, the laptob user want to use an application in the server but the user shoud pass all the routers between him and the server (R1,R2,R3) so what is the additional configuration should we add to make him able ...
I already solve the problem.The problrm was that I was enterning the command in the configuration mode while I should write it after the globle mode.The problem now that tunnel is ok (up) but there is no ping between the internal LANs ( networks behi...
Thanks Pablo,I did the configuration as mentioned in cisco website but from the debug the router asked me for Xauth username and password so what does he mean?1- Does he mean we should create username and password in the main router (EZVPN Server) or...
Thanks Mr. TimWe don't have a local cisco systems team in our country.C3750 METRO is good, so from it's Datasheet :http://www.cisco.com/en/US/prod/collateral/switches/ps5718/ps5532/product_data_sheet0900aecd806e27b9.htmlIt looks like an edge router a...
I can't open the link becuase it need an authorization.The command gives me the IP address for the client but it doesn't give me the client's username.Is there another command can show me the username with it's IP address ?Regards.
Did you make restart after you do these settings ?If problem didn't solve I think Cisco Small Business Support Center will do all their best to solve it..regards
