Currently I have problems with Cisco SG350 model, in these I configure its ports in Access mode with a specific vlan, but after they are turned off or restart by electrical issues, all its ports lose configuration and are automatically put in trunk mode with all the vlan declared in the switch, this only happens to me with this specific model, does anyone know how I can solve so that the configuration is not changed when restarting?
we try updating the firmware but the issue persists
1. Log into CLI of DNAC:
ssh maglev@< DNAC appliance IP> -p 2222
2. Run this curl command to get token to get member id:
curl -X POST -u admin:<admin user password> -H -V https://<CLUSTER-IP>/api/system/v1/identitymgmt/token
Enterprise Switching Business Unit is glad to announce Beta release 16.12.2 for all Catalyst 9200/9300/9400/9500/9600 and Catalyst 3650/3850 Platforms. This release is made available to allow users to test, evaluate and share fee...
Purpose of the document
This document describes the general recommendations or best practices when designing and deploying the Cisco SD-Access technology. The document assumes that the reader has a general overview of Cisco's SD-Access for Distributed C...
Do you currently have hands-on networking experience? If you do, we'd love to hear from you!
Your feedback will be reviewed and analyzed by our team to directly influence a networking management and monitoring product.
Take the 20-min or les...