Cisco Switch 2960X-48LPD Radius configuration

[Antony.xavier]

Hi There,

I recently upgraded Cisco Switch 2960X - 48 LPD from 15.2(7)E5 to 15.2(7)E5 after the upgrade I am not able to authenticate through Radius server.

Please note: Radius authentication was working fine in the pervious IOS version 15.2(7)E5.

Please guide me the CLI configuration steps to performed.

Regards,

Antony Xavier

[Jitendra Kumar]

check below documents will guide you for the Radius config...

config command also available..

https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst2960x/software/15-0_2_EX/security/configuration_guide/b_sec_152ex_2960-x_cg/b_sec_152ex_2960-x_cg_chapter_010000.html

Thanks,

Jitendra

[marce1000]

        - What's in the logs of the radius server ?

 M.

[Antony.xavier]

Hello Everyone,

I was able to configure NPS radius  server, below is the configuration. FYI.

config t

radius server (name of the server)

address ipv4 1.1.1.1 auth-port 1612 acct-port 1613

key 0 XXXXXXXX

exit

config t

aaa group server radius (name of the radius server)

server name (name of the server)

exit

regards,

Antony

[Jitendra Kumar]

Congratulation you are a rock star..

Thanks

Jitendra

[MHM Cisco World]

radius-server host x.x.x.x auth-port 1612 key y.y.y.y

try this way