05-02-2015 09:43 AM - edited 03-07-2019 11:50 PM
Hello community,
We has a 6509-E with the following modules:
I test the Power Supply with two 110v and with two 220v lines, but i only receiving 807.24 Watts from the Power Supply.
I see very stranger that in the output of the Show Power command, this doesn't show the Power Supply model, it said "none".
The documentation of WS-CAC-6000W saids that i need IOS 12.2(18)SXD and later, and i has 12.2(18)SXD7b.
This is the output of SHOW POWER:
====================================================================
Router#show power
system power redundancy mode = redundant
system power redundancy operationally = non-redundant
system power total = 0 Watt
system power used = 807.24 Watts (19.22 Amps @ 42V)
system power available = 807.24 Watts (19.22 Amps @ 42V)
Power-Capacity PS-Fan Output Oper
PS Type Watts A @42V Status Status State
---- ------------------ ------- ------ ------ ------ -----
1 none
2 none
Pwr-Allocated Oper
Fan Type Watts A @42V State
---- ------------------ ------- ------ -----
1 WS-C6509-E-FAN 150.36 3.58 OK
Pwr-Requested Pwr-Allocated Admin Oper
Slot Card-Type Watts A @42V Watts A @42V State State
---- ------------------ ------- ------ ------- ------ ----- -----
3 WS-X6748-GE-TX 407.40 9.70 - - on off (FRU-power denied)
5 WS-SUP720-3BXL 328.44 7.82 328.44 7.82 on on
6 (Redundant Sup) - - 328.44 7.82 - -
====================================================================
Any help will be appreciate.
Thanks beforehand.
05-02-2015 01:05 PM
Hi,
It maybe a bug in the version of IOS you are running. Upgrade to a newer version and test again.
HTH
05-02-2015 01:46 PM
Hi Reza,
Thanks for answer.
I test too with 15.1(1)SY, and get the same results.
Another idea?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: