- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-23-2010 08:30 PM - edited 03-06-2019 11:44 AM
hi! what's the command to clear an gigaethernet internface config on a 4506e sw? currently there are lots of qos and security stuffs on some of the gigaethernet port. instead of using the no command for each of the line, is there a command to clear all these config? i just want to configure access vlan on the port.
thx.
Solved! Go to Solution.
- Labels:
-
Other Switching
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-23-2010 08:52 PM
You can try to use below command on the configuration mode....
xxx-xxx(config)#default interface gigabitEthernetx/x - specify the port that you would like to clear the configuration...see whether it works or not.
And let me know later
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-23-2010 08:52 PM
You can try to use below command on the configuration mode....
xxx-xxx(config)#default interface gigabitEthernetx/x - specify the port that you would like to clear the configuration...see whether it works or not.
And let me know later
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-05-2016 03:27 AM
Hi there,
I tried the above command and it works.
Thanks,
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-12-2016 08:45 AM
Worked for me too, thanks!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-11-2019 07:00 AM
Worked for me as well.
Thanks!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-11-2019 11:09 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-17-2021 08:11 PM
Thank you!!
I did have to type it as autocomplete wouldn't work for some reason?
Either way it worked and thank you !!!
