ANNOUNCEMENT - The community will be down for maintenace this Thursday August 13 from 12:00 AM PT to 02:00 AM PT. As a precaution save your work.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
191
Views
0
Helpful
3
Replies
Highlighted
Beginner

Command Auto complete in CLI problem

I have problem with the command auto completion in packet tracer's CLI. I was trying that with the 'Tab' key, but it's not working. Is there any other method for command auto completion?SwitchingFAQF,A,Q

3 REPLIES 3
Highlighted
Beginner

Re: Command Auto complete in CLI problem

 
Highlighted
Collaborator

Re: Command Auto complete in CLI problem

 

it works for those commands that are in packet tracer. PT is a software simulator to simulate real IOS but it is not real IOS so some commands are missing and some behavior is simplified.

 

Regards, ML
**Please Rate All Helpful Responses **

Highlighted
VIP Advisor

Re: Command Auto complete in CLI problem

Hi @Jimi_patel 

 

The autocomplete function works when the entered command leaves no other possible option.
For example, in a switch layer 3, if you enter ip rout and press tab, the command will not complete, since there is more than one possible option (ip route and ip routing).
For this reason, I suggest you review that what was entered before the tab does not leave more than one possible option.

 

Regards

Content for Community-Ad