I face this problem when trying to login on config mode at Cisco Catalyst 4510R+E Switch :
CORE>en
Password:
CORE#conf t
Enter configuration commands, one per line. End with CNTL/Z.
CORE(config)#
Config mode locked out until standby initializes
or is recovered from recovery mode if it is a virtual switch
Command execution is locked, Please try later.
CORE(config)#
Config mode locked out until standby initializes
or is recovered from recovery mode if it is a virtual switch
Command execution is locked, Please try later.
CORE(config)#
=========>
CORE# sh module
Chassis Type : WS-C4510R+E
Power consumed by backplane : 40 Watts
Mod Ports Card Type Model Serial No.
---+-----+--------------------------------------+------------------+-----------
1 48 1000BaseX SFP WS-X4748-SFP-E CAT2202L5DH
2 48 1000BaseX SFP WS-X4748-SFP-E CAT2202L5BV
3 48 10/100/1000BaseT EEE (RJ45) WS-X4748-RJ45-E CAT2204L14Z
4 48 10/100/1000BaseT EEE (RJ45) WS-X4748-RJ45-E CAT2204L14U
5 Supervisor
6 8 Sup 8-E 10GE (SFP+), 1000BaseX (SFP) WS-X45-SUP8-E CAT2204L2BM
M MAC addresses Hw Fw Sw Status
--+--------------------------------+---+------------+----------------+---------
1 00be.7504.c280 to 00be.7504.c30f 1.0 Ok
2 00be.7504.b720 to 00be.7504.b74f 1.0 Ok
3 00be.7524.b348 to 00be.7524.b367 1.1 Ok
4 4c77.6dde.e8c9 to 4c77.6dde.e8f8 1.1 Ok
5 Unknown Unknown Unknown Other
6 4c77.6d35.8288 to 4c77.6d35.848f 1.3 15.1(1r)SG5 03.08.05.E Ok
Mod Redundancy role Operating mode Redundancy status
----+-------------------+-------------------+----------------------------------
5 Standby Supervisor SSO Disabled
6 Active Supervisor SSO Active
System Failures:
----------------
Power Supply: bad/off (see 'show power')
===========>
i know that , this is a problem at specific module " module 5" , i try to disconnect it and connect it again but nothing new ! any other solution ??
