WS-4900M switch with following IOS
Cisco IOS Software, Catalyst 4500 L3 Switch Software (cat4500e-ENTSERVICESK9-M), Version 12.2(46)SG, RELEASE SOFTWARE (fc1)
and image name :
System image file is "bootflash:cat4500e-entservicesk9-mz.122-46.SG.bin"
Found the configuration guide at this URL:
But there are different images file names available for the same IOS version, not all commands are supported by all images so which one is the exact configuration guide for 12.2(46)SG and image name-- Cat4500e-entservicesk9-mz.122-46.SG.bin.
Pls share the link.
Go to Solution.
configuration guides are not split / differentiated per feature set ( ipbase, enterprise or other).
However, each chapter includes at the beginning a short note or a sentence to say what feature set is needed for running the feature described in it.
Hope to help
View solution in original post
Try this link
Regards, Alex. Please rate useful posts.
Looks like it's the same configug guide that I had earlier refered to.
Different images like ipbase, ent , entk9 have some different command sets available.
Some of the commands ( ip polocy routing ) is not supported on our switch but those are given in the attached config guide.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: