configuration
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-29-2022 11:50 PM
i have one router and two interface f0/0 ip add 10.1.1.1 second is e0/0 ip add 20.1.1.1 so what is the commands for configuration
- Labels:
-
Other Switches
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-29-2022 11:59 PM
can you explain requirement more? what you need to configure on router?
Good luck
KB
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-30-2022 12:05 AM
1.
Make the end to end connectivity Between all
MAG-13214.txt
site.
on Site 3 means area 27 R1 network(137.46.46.32/27 should come on
R2 network(137.46.46.0/27) should not come Site 3 means area 27 R3 network(137.46.46.64/27 should come on Site 3 means area 27
When you check routing table on R7 Router,
137.46.46.0/24 shoud not be appear in routing table of R7 Router. 137.46.46.32/27 shoud be appear in routing table of R7 Router. 137.46.46.64/27 shoud be appear in routing
table of R7 Router.
Verification
Ping From R5 router to R2 Router that should be reachable.
R5#ping 137.46.46.28 Should be 100%
R5#ping 137.46.46.61 Should be 100%
R5#ping 137.46.46.92 Should be 100%
