Configure CBQoS for monitoring.

[martin.germano]

  Hi, i want to configure CBQoS in a lot of 2960 switches (with snmp v1) for monitoring: jitter, delay and packets lost with PRTG software.

  I not found documentation for understand CBQoS, but i see this doc:

http://www.cisco.com/en/US/docs/ios/ios_xe/qos/configuration/guide/cbqos_mib_xe.html

  and when i put these commands:

1. enable

2. configure terminal

3. snmp-server ifindex persist

4. snmp mib persist [cbqos | v3mibs]

5. end

6. write mib-data

  I can't do the step 4

Switch(config)#snmp mib ?

  community-map     Community Mapping as per RFC-2576

  notification-log  Configure the Notification Log MIB

  rep               Enable SNMP Resilient Ethernet Protocol options

  target            target extention CLI from SNMP

PS: Or maybe is a simplest way to monitor QoS.

Thanks!

[martin.germano]

I realy sorry, i didn't realise for the IOS version. I'm replying myself:

  Upgrade IOS:

c2960-lanbasek9-mz.122-55.SE8

to

c2960-lanbasek9-mz.150-2.SE4

Switch(config)#snmp mib ?

  community-map     Community Mapping as per RFC-2576

  notification-log  Configure the Notification Log MIB

  persist           Persistence for MIBS

  target            target extention CLI from SNMP

Now, i wiil try to get work CBQoS.

Thanks