Configure hwic and ehwic in same 1941 router

[eaprice2008]

Hi There,

I had a 9 port hwic-d-9esw installed in a 1941 router.

I then needed to add some more Gigabit interfaces into the router and purchased a ehwic-4esg.

They are both showing up in the inventory but i now only have access to the interfaces on the EHWIC.

Is there a way i can use both on the same router?

Photo Attached.

[Georg Pauwen · Accepted solution]

Hello,

according to the document below, you cannot use the EHWIC-4ESG in conjunction with the HWIC-D-9ESW:

-->You cannot use the EHWIC switch in conjunction with the HWICs with part numbers HWIC-4ESW and HWIC-D-9ESW and the network module with part number NM-16ESW/NM-36ESW.<--

http://www.cisco.com/c/en/us/products/collateral/interfaces-modules/qa_c67-612908.html

[eaprice2008]

ah that settles it then, thanks for finding that information.