Configuring a trink on a SG200-26

[BigD63]

Hello,

I am running a QNAP TS431-K NAS, it is plugged into ports 23 and 24 on the Switch, both support trunking.

How do I configure the trunk on the switch side?

If i have to setup a VLAN, will I have to setup a route for it to still be reachable by the rest of the devices on that switch as they would be on a different vlan?

Thanks,

D

[balaji.bandi]

if you looking bundle 2 interface use the below document :

https://www.cisco.com/c/en/us/support/docs/smb/switches/cisco-small-business-200-series-smart-switches/smb97-link-aggregate-group-lag-configuration-on-200-300-series-man.html

[BigD63]

Hey thanks for the link.  I will dig into this later this evening and let you know how it went or if i have further questions.