Configuring NetFlow on a WS-C4948 (15.0(2)

[BeckyBoo123]

Hi All,

I am trying to setup netflow on my old WS-C4948 but I think its just too old! I've used the following config on other newer devices:

enable
configure terminal
ip flow-cache timeout active 1
ip flow-cache timeout inactive 15
ip flow-capture vlan-id
ip flow-capture mac-addresses
ip flow-export version 9 origin-as
ip flow-export destination 10.11.210.12 2055

# IOS version 12.0(22)S, 12.2(14)S, or 12.2(15)T
interface GigabitEthernet0/1
ip flow ingress

# IOS older than 12.0(22)S, 12.2(14)S, or 12.2(15)T

interface GigabitEthernet0/1
ip route-cache flow

If I type ip ? it doesn't give me any option to enter flow-cache or flow-export.

Can anyone shed any light on this?

[marce1000]

 - Ref : https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst4500/12-2/15-02SG/configuration/guide/config/nswich_l.html

   Apparently your device only does netflow-lite   , look at the below link for differences :

               https://community.cisco.com/t5/switching/netflow-v-s-netflow-lite/td-p/1892027

  M.