Member since ‎01-03-2018

User Statistics

  • 77 Posts
  • 0 Solutions
  • 100 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
50 Replies
20 Replies
10 Replies
5 Replies

User Activity

Hey! I have Googled the life out of this question and I am not getting very far.I have console access to my 1140 but I cannot gain GUI access to set it up as its still configured with default settings.I wasn't presented with the setup wizard on the C...
Hi All, I have recently upgraded my PC to a preview of Windows 11 and now I can't get my ASDM software to connect to our firewall.The software launches, I enter the destination and my creds but then it says "Unable to launch device manager from x.x.x...
Hi All, I am trying to setup netflow on my old WS-C4948 but I think its just too old! I've used the following config on other newer devices: enable configure terminal ip flow-cache timeout active 1 ip flow-cache timeout inactive 15 ip flow-capture vl...
Hi All,We are a little behind the times and up until now we've been using analogue phone lines that connect up to a traditional PBX system.We are now rolling out VoIP handsets to a test location which have been provided to us by Masergy. There is no ...
Hi all, I have a Cisco C921-4PLTEGB currently connected to the EE network using its Cellular interface.I have one VLAN (VLAN10) setup to connect back to our corporate network via a tunnel. All traffic by default should go down this tunnel for DHCP (1...
Community Statistics
Member Since ‎01-03-2018 05:52 AM
Date Last Visited ‎02-23-2022 12:07 AM
Posts 77