Configurint PortChannel for vmware connection

[mdrangell22]

Hello Guys

I need to make a portchannel from my switch to a Vmware Esxi 6.5 In my Vmware vSwitch I will use Route base on IP Hash. I don't know if in this  vmware version support PAGP or I have to configure  mode on

I need to know if the following commans are enought in my switch portchannel?

interface GigabitEthernet 0/10
switchport mode trunk
channel-group 20 mode active
!
interface GigabitEthernet 0/11
switchport mode trunk
channel-group 20 mode active

interface Port-channel1
switchport
switchport mode trunk

[marce1000]

 - Below are some configuration examples : from Cisco site I would set mode on

 https://kb.vmware.com/s/article/1004048

 https://kb.vmware.com/s/article/2034277

 M.