Connecting Cisco switch with 3rd party switch via fibre trunk

00u1igd22mdDeAUFy5d7 · ‎08-21-2021

Hi All

can anyone assist with the following

I am trying to connect a Cisco 250 series switch to an industrial DLink switch DIS-200G-12PS

via a fibre trunk link using Chimera GBics 10G Sfp interfaces

If I connect both switches using a copper link it works fine.

I have proven the LC patch lead

I have proven the GBics

I can see the GBic in system status though fibre link is down

it looks as though there’s a protocol problem or handshake issue but I’m guessing

any assistance greatly appreciated

Rob Davies

marce1000 · ‎08-21-2021

- Check the logs on both platforms, when trying to establish the link.

M.

-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '

paul driver · ‎08-22-2021

Hello

The fibre sfps need to be compatible to the fibre you are using and between each other, be it

Short hual (SX) or Long haul (LX), Multimode (MM) or Sinlge mode (SM) sfps

Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.

Kind Regards
Paul

00u1igd22mdDeAUFy5d7 · ‎08-22-2021

Thanks for reply
I’ve since checked the spec of both switches and found the Dlink switch sfp port is 1000M while the Cisco switch ports are SFP+ so think this is probably my issue