Connection between catalyst 2960 x switch and allied telesyn 8000s switch

[rajesh_raj414]

Hi,

i want to connect my new allied telesyn 8000s Access switch with  cisco catalyst 2960x series switch.

both are configured in same vlan(vlan1). iam able to communicate between with ethernet ports but while connecting sfp modules communicate failed.

is there any encapsulation,trunking  req in switches,

help me to clear the issue. thanks in advance.

[paul driver]

Hello

"both are configured in same vlan(vlan1). iam able to communicate between with ethernet ports but while connecting sfp modules communicate failed."

Are these switches already connected to each other via access ports and you wish to connect instead via sfp modules?

If so are the sfp's compatible -
Media type (fibre/gbic)  -
What cabling is being used


res

Paul

[rajesh_raj414]

Hi Sir,

now one access port connected from cisco switch to  AT-Media Convertor, and  terminated at  AT-switch  with  fiber optic module(SFP Module), 

In both the places we using MM SFP MODULES

Media Type:Fiber

Cabling : MM OFC

plz conforme me how to check the compatibility between these two SFP's

[sbhadrav@cisco.com]

If the default configuration is satisfactory, the switch does not need further configuration. You can use any of these management options to change the default configuration:

Start the Network Assistant application, which is described in the getting started guide. Through this GUI, you can configure and monitor a switch cluster or an individual switch.
Use the CLI to configure the switch as a member of a cluster or as an individual switch from the console.
Use the Cisco Prime Infrastructure application.