Connectivity issue between CIsco and Juniper Ex4200 switch
we have connectivity between cisco and Juniper Ex 4200 switch with only acces port configuration .But in Juniper Switch its showing stp blocking mode ,Can anyone help me in this below are my switch config
interface GigabitEthernet1/0/24 switchport access vlan 55 switchport mode access speed 100 duplex full end
1489654@IN_CHN_FUT_T3_L3A_11> show configuration | display set |match ge-0/0/36 set interfaces ge-0/0/36 no-traps set interfaces ge-0/0/36 ether-options link-mode full-duplex set interfaces ge-0/0/36 ether-options speed 100m set interfaces ge-0/0/36 unit 0 family ethernet-switching port-mode access set interfaces ge-0/0/36 unit 0 family ethernet-switching vlan members VC set protocols rstp interface ge-0/0/36.0 edge
Hello guys.I installed remote access VPN on Windows 2019. I need to do additional configuration on the router to allow access outside. I got this.Public IP--------------ISP Router-------------Fa0/0 Cisco Router Fa0/1------------------------My Server ...
Meet the Authors video - How to Troubleshoot Network Problems with Vinit Jain
(Live event – Wednesday, February 12th, 2020 at 10:00 a.m. Pacific / 1:00 p.m. Eastern / 7:00 p.m. Paris)
This event had place on Wednesday 12th, February 2020 at 10hrs PDT&nbs...
I have a pair of 3945 routers that are proving to be underpowered for the 100+ remote offices connecting to them. Fortunately I happen to have a couple of 4351 ISRs rated for significantly greater encrypted throughput. Is there any way I could upgrade the...
This article assumes you have the basic knowledge and experience with Cisco DNA Center and Identity Services Engine (ISE).Note when reading this doc the "Authentication Policy" referred to is part of Cisco DNA Center Onboarding section and ha...