Controling test-lab?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-09-2018 03:59 AM - edited 03-08-2019 02:34 PM
Hello everyone,
I'm searching for a productive way to control the Test-lab.
in the lab there are many devices. switches, routers, Wlc ....etc
What I'm searching for is . for ex, after finishing our test, re-back to the previous-config. any Cisco software or ... ? any recommendation ?
Many thanks
- Labels:
-
Other Switching

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-09-2018 05:51 AM
Hi Muayyad,
Do you want to revert back to the original base config? If yes, you can deploy original config and archive it as a first step. Then you can revert back to it anytime manually or after timer expires.
HTH,
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-09-2018 07:03 AM
yes, that exactly what I want, but because there are many racks, and more than 200 devices, I'm looking for something more centralized, prodactive. I've already saved the config in flash to revert it in case something happen.
Thanks
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-09-2018 07:35 AM
For Cisco tool i can think of Prime or Cisco CNA. There other third party software that you could use or you can actually script it and do it from a server that has access to every single device. Or you can send the command through SNMP.
Can't think of anything else.
HTH,
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-09-2018 11:26 PM
