Hi,For Cisco tool i can think of Prime or Cisco CNA. There other third party software that you could use or you can actually script it and do it from a server that has access to every single device. Or you can send the command through SNMP.Can't thin...
Hi Raj Kumar L,It seems that port 49 on the server is closed. Could you try telnet ip port and see if you get connection? If not i would go on server and check the listening ports.HTH,
Hi Muayyad,
Do you want to revert back to the original base config? If yes, you can deploy original config and archive it as a first step. Then you can revert back to it anytime manually or after timer expires.
HTH,
Hi anousakisioannis,I would suggest Cisco best practices documents for improvements regarding your network. Security and basic configuration wise the Cisco Guide to Harden Cisco IOS Devices is a good start:https://www.cisco.com/c/en/us/support/docs/...
Hi GiuseMR,For Autonomous mode there is the Public Secure Packet Forwarding (PSPF) option to isolate clients (use of bridge groups). For WLC architecture there is the peer to peer blocking mode available on the WLC.The single point setup is controlle...