Convert 9300_48p stack to 9300_24p stack

[lowfell]

I need to convert a two switch  9300_48p stack to a two switch 24p stack. Can i just do a more or less cut n paste?

What about this line crypto pki certificate pool
cabundle nvram: *****

Can i copy that as well?

What other bits will I need to change or can i copy verbatim within reason?

[balaji.bandi]

Yes, you can configure the same settings on the lower model and remove the last 24-port configuration, as the new switch has only 24 ports.

Make sure it is running the same version of code for the commands to work as expected.

Do not copy the crypto config; configure the rest of the information related to the configuration.

[lowfell]

Hello & thank you Balaji.  These commands are present in the Crypto config how can i regenerate them without copying?
!
!
crypto pki trustpoint TP-self-signed-1234567890
enrollment selfsigned
subject-name cn=IOS-Self-Signed-Certificate-1234567890
revocation-check none
rsakeypair TP-self-signed-1234567890
!
crypto pki trustpoint SLA-TrustPoint
enrollment terminal
revocation-check crl
!
! 
crypto pki certificate chain TP-self-signed-1234567890
certificate self-signed 01
then there is a certificate 
quit

crypto pki certificate chain SLA-TrustPoint
certificate ca 01
then another certificate

[Giuseppe Larosa]

Hello @lowfell ,

the certificates are self signed and they are specific and local of each device. I think you should not copy these sections on new device.

You should find something equivalent on new device

Hope to help

Giuseppe

[lowfell]

Thanks again Giuseppe. I am going to site on Monday so i'll see how i get on.