cpu1 and cpu2 usage in stack switch

[csco11579831]

Hello,

How to find separate cpu1 and cpu2 usage in stack switch cisco 3570 ?

Best regard,

[Ankur Arora · Accepted solution]

Hi,

I am not sure how to check that using SNMP walk.

But following is the way to check it using switch CLI.

For example, you have a stack of 3 switches. Switch 1 is the master.

So when you do a Show proc cpu sort, you check the CPU of the master i.e. Switch 1 in this case.

Now in order to check the CPU of member switches 2,3 you have to do the following:

#session 2 (this will login you into the second switch of the stack)

#show proc cpu sort (this will tell you the cpu of the second switch

#exit

Similarly for the 3rd switch of the stack:

#session 3

#show proc cpu sort

Thanks

Ankur

"Please rate the post if found useful"

[csco11579831]

Hi,

beslown the result:

BBO#session ?

  <1-9>  Switch number

BBO#session 2

Command authorization failed.

i try this,but does not working

BBO#session 2 ?

  processor  destination processor for session

[Ankur Arora · Accepted solution]

Hi,

The reason you are getting the error Command authorization failed. is because your user access doesn't have enough privilages to run this command. You might have a tacacs configured on the switch with a lower privilage level for your account.

Thanks

Ankur

[csco11579831]

OK,thanks for reply!