create a non privilege user, which use all command SHOW
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-13-2019 03:55 PM
Hi,
I need to create a non privilege user, but this user need to use all command SHOW. For authentication I must use radius server.
Have you some ideas how can i configure it?
- Labels:
-
Catalyst 2000
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-13-2019 05:25 PM
here is the example guide to follow and setup one ;
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-13-2019 06:46 PM
Hi,
The Radius protocol does not support command level authorization. That is mostly the job of ACS server.
Here is a document explaining Radius deployment but you may not be able to assign privileges.
https://aaronwalrath.wordpress.com/2007/10/20/radius-authentication-for-cisco-router-logins/
HTH
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-13-2019 07:02 PM
Hello
Locally you can do this - Try the follwoing:
username xxx privilege 1 secret xxxx
privilege exec level 1 show running-config
privilege exec level 1 show
Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.
Kind Regards
Paul
