I've seen several threads and articles on this situation but have not yet come to a conclusion - I'm assuming the issue is due to an IOS incompatibility but according to Cisco documentation this is not the case.
I'm trying to get both the data and voice vlans on our 2960S stack to fail in an authorized state when the AAA server is not reachable. I am able to configure the data vlan as such using the following commands :
authentication event server dead action authorize <vlan_id> <-- causes the data vlan device to become authorized on the ports native vlan or assigned vlan; vlan id is optional
authentication event server alive action reinitialize <-- causes the data vlan device to reauthenticate once the AAA server comes up again
However, the voice authorization command is not available in this IOS, even though the Cisco admin guide has this command listed for this IOS. See the link below :
The 2020 IT Blog Awards, hosted by Cisco, is now open for submissions through October 16. Submit your blog, vlog or podcast today. For more information, including category details, the process, past winners and FAQs, check out: https://www.cisco...
Hello,We have a pair of N3K-3064PQ-10GX and one of them acting as backup and we want to migrate from VyOS to it, we want to add 500x interface vlan and each interface vlan has its own ip/prefixes (for example /30 /29 ...) and we ahve 6-8x BGP session with...
We live in an age that is both thrilling and evolving substantially. A new trend/technology is always on rise even before the preceding has been used to its fullest potential. Although the concepts of digital transformation may seem over discussed, ...
Show CommandPurposeCiscoICX-RuckusShow Spanning tree infoShow spanning-treeshow 802-1wVerify Port-Channel / Link aggregation infosh lag briefsh etherchannel summaryShow CDC/LDP neighbor infoshow cdp neighbors detailsh lldp neighbors de sh mac a...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.