Cross-Stack Etherchannel to Hirschmann switch possible?

[jthoele]

Hello all,

I am looking to add a catalyst 9200 2 member stack into a network as a new layer 3 core for vlan routing.

The access switches are Hirschmann GRS1030's and RSP30's.

Ideally, I would like to utilize cross-stack etherchannel from the 9200 stack to the hirschmann switches.

Has anyone had any experience / issues with this configuration?

Has anyone had issues with a cisco cross-stack etherchannel to a third party access switch?

thanks in advance!

[Reza Sharifi]

Hi,

I have never used Hirschmann switches before but have used other vendors switches like Juniper connecting to Cisco stacks with no issues. Most vendors support standard protocol like LACP or mode "on".

HTH