cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Cisco Community Designated VIP Class of 2020

97
Views
0
Helpful
2
Replies
Participant

Curious why Show Commands display Load for Five Secs:

I have been trying to find the answer but after my attempts failed I am hoping y'all can help. What commands are added to a switch/router to show the out put below every time I run a show command? After starting up a stack of new switches this output was not displaying the load. However, after applying my template the load is showing and I am curious what causes it to work.

 

Load for five secs: 38%/0%; one minute: 40%; five minutes: 40%
Time source is NTP, 15:27:03.581 CST Mon Jan 13 2020

 

This is displayed when I run a show running-config, show logging etc.

 

Thanks in advance

2 REPLIES 2
Highlighted
Hall of Fame Community Legend

Re: Curious why Show Commands display Load for Five Secs:

What firmware is the stack running on?
Participant

Re: Curious why Show Commands display Load for Five Secs:

Thanks for responding Leo. This is not a problem and more of a I need to know situation. The switch stack is 2 - 2960X-48FPS-L and they were upgraded to 15.2(7)E0a.

 

Thanks!

CreatePlease to create content
Content for Community-Ad