09-24-2008 08:50 AM - edited 03-06-2019 01:34 AM
dear all
when i implement
Policy Map qos-in
Class c-video
priority 1 (%)
or
bandwidth
in sup 720 5/2 module
it show
bandwidth percent command is not supported in input direction for this interface
or
priority command is not supported in input direction for this interface
the question is does 6509 support priority or bandwidth command with policy-map
or
it can support in other interface like
48 port 10/100/1000 fiber or utp module
pls advice
tks
09-24-2008 09:37 AM
I am using Sup 720's and it is supported on mine.
policy-map NJ_voice
class NJ_voice
priority percent 25
09-24-2008 09:43 AM
hi
tks
and can you tell me your IOS version
and which interface you apply service-policy
Wan Module? or ethernet Module
Module Model?
tks
09-24-2008 09:51 AM
I STUDY 6500 PFC CONFIG GUIDE
IT WROTE PFC DOES NOT SUPPORT
IS THAT RIGHT?
Policy Map Command Restrictions
PFC QoS does not support these policy map commands:
⢠class class_name destination-address
⢠class class_name input-interface
⢠class class_name protocol
⢠class class_name qos-group
⢠class class_name source-address
Policy Map Class Command Restrictions
PFC QoS does not support these policy map class commands:
⢠bandwidth
⢠priority
⢠queue-limit
⢠random-detect
⢠set qos-group
⢠service-policy
09-24-2008 09:58 AM
IOS version 12.2(33)SXH2a.
Its applied to a Multilink interface. I dont believe you can apply it to a ethernet switchport. Usually you would have your switch ports trust any QoS markings so they are passed through the network and then have your service policy which is on your WAN interface, catching those marked packets and dealing with them accordingly.
09-24-2008 11:03 AM
LLQ is not supported on ethernet/VLAN interfaces in 6500s
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide