
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-28-2008 12:59 AM - edited 03-06-2019 01:02 AM
Is there a way of changing the config of an interface or range of interfaces back to there default configuration without having to work through all the commands and negateing them?
The switches we use are 2950, 2960, 2970, 3750 and 6500.
Thanks
Solved! Go to Solution.
- Labels:
-
Other Switching
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-28-2008 01:05 AM
Hello Jon,
you can use
default interface type x/y
default interface range ....
from global config
Hope to help
Giuseppe
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-28-2008 01:05 AM
Hello Jon,
you can use
default interface type x/y
default interface range ....
from global config
Hope to help
Giuseppe
