Default route through DMVPN And OSPF

[Blason R]

Hi Guys,

I have topology like this and would like to achieve default gateway pointed towards hub location through Spoke 2 [RS3] where I have two MPLS links terminated.

Rest everything is working fine where I have MPLS and one ISP but not sure about two MPLS. I am pretty novice to Dynamic Routing concepts hence would really appreciate if someone can help here!!

TIA

[Georg Pauwen]

Hello,

hard to say without seeing the OSPF configurations of RHU and RS3, can you post those ?

Basically, on RS3 you could configure different OSPF costs for each tunnel (ip ospf cost), and on RHU, configure the 'default-information originate always metric' command to send the default route to RS3.

Either way, post the configurations of both routers, that will make it easier to figure this out...