Delete

110

Views

Helpful

Replies

Highlighted

Delete

Latest Contents

PRTG monitoring - Sensor Syslog receiver not receiving all ...

Created by Barry Landon on 01-24-2020 05:20 AM

PRTG system in place running other sensors on the same host, which are working. Ive added syslog receiver sensor and receiving PRTG data from switch that increases drops, errors and warning stats that disappear after a few minutes. Within mess... view more

Setting up a GRE tunnel (IP-NAT, GRE AND IPSEC)

Created by Bananaman on 01-23-2020 02:00 PM

Hi, here is an example how to configure IP-NAT, GRE, IPSEC. I've seen plenty of questions and this might be a good solution! (Mostly the use of commands that might remind u) IP NAT======================================================================... view more

OSPF "INIT/DROTHER" error

Created by MrMaregaTech on 01-22-2020 04:45 AM

Hi everyone.I have a problem in my Network.So i have 3 routers and a firewall in my topology. I have configured OSPF and all routers works expect R3 (see in the image below)When I watch my neignbor in R3 it says :192.168.7.7 1 INIT/DROTHER 00:00:37 10.0.2... view more

How to SDA Host Onboarding with ISE

Created by ldanny on 01-19-2020 04:48 AM

Introduction Host Onboarding is the term used when connecting an endpoint (hosts , IOT , Other devices) to the fabric , and can be accomplished in a couple of ways.One option is the "static" approach as oppose to the dynamic and secure approach using&nbs... view more

Cisco ASA failover status, Sensor for PRTG

Created by Oleg Volkov on 01-17-2020 10:10 AM

Hello!We update our ASA Failover sensor for PRTG.Improve usability.New manuals.You can read about it in attachment file.Download sensor from: http://www.powerc.ru/download/asafailover.zip

CreatePlease to create content