Device won't connect with VLAN

[AdamMattsson]

Hello.

I'm currently working on an assignment for my networking class. The project is made up of a multilayer switch with 5 vlans which are inherited by the switches. Every VLAN has an IP address and a helper address. VLAN 10-40 works but for some reason VLAN 50 refuses to work. Every device connected to ports with access to VLAN 50 won't turn green. I've been trying to fix this for days to no avail.

I have included the file below.

Thanks.

[Reza Sharifi]

Hi,

If you issue "sh vlan" do you see vlan 50 in the list and the ports that are assigned to it?

HTH

[AdamMattsson]

Hi. 

I do not, but that applies to the other ones that work perfectly fine.

[AdamMattsson]

I am using vtp to pass on vlans.

[Reza Sharifi]

Can you disable vtp or put all the switches in "transparent mode" and test again?

[Martin L · Accepted solution]

You forgot about VTP Password. they have to match and once you configure one, all switches must have one.

Use Show vtp password  to find and fix it a mistake.

Regards, ML
**Please Rate All Helpful Responses **

[AdamMattsson]

This worked. Thank you very much!

[Martin L]

np, it happens to all of us;   too much putty and cli; etc.

Regards, ML
**Please Rate All Helpful Responses **