05-12-2021 01:05 PM
Hello.
I'm currently working on an assignment for my networking class. The project is made up of a multilayer switch with 5 vlans which are inherited by the switches. Every VLAN has an IP address and a helper address. VLAN 10-40 works but for some reason VLAN 50 refuses to work. Every device connected to ports with access to VLAN 50 won't turn green. I've been trying to fix this for days to no avail.
I have included the file below.
Thanks.
Solved! Go to Solution.
05-12-2021 01:48 PM - edited 05-12-2021 01:49 PM
You forgot about VTP Password. they have to match and once you configure one, all switches must have one.
Use Show vtp password to find and fix it a mistake.
Regards, ML
**Please Rate All Helpful Responses **
05-12-2021 01:11 PM
Hi,
If you issue "sh vlan" do you see vlan 50 in the list and the ports that are assigned to it?
HTH
05-12-2021 01:19 PM - edited 05-12-2021 01:20 PM
Hi.
I do not, but that applies to the other ones that work perfectly fine.
05-12-2021 01:19 PM
I am using vtp to pass on vlans.
05-12-2021 01:38 PM
Can you disable vtp or put all the switches in "transparent mode" and test again?
05-12-2021 01:48 PM - edited 05-12-2021 01:49 PM
You forgot about VTP Password. they have to match and once you configure one, all switches must have one.
Use Show vtp password to find and fix it a mistake.
Regards, ML
**Please Rate All Helpful Responses **
05-12-2021 01:55 PM
This worked. Thank you very much!
05-12-2021 02:02 PM
np, it happens to all of us; too much putty and cli; etc.
Regards, ML
**Please Rate All Helpful Responses **
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide