HI, I'm working through the ccna voice lab manual, i have the setup on the router up to the point of getting DHCP setup on the router. I added the commands in the book to setup dhcp on the router but then it moves to testing the connectivity. It says to then connect a pc to the switch and check to see if it gets a DHCP assigned address out of the Data vlan. To me it seems like there would have to be some additional configuration on the switch for this to hand out DHCP addresses right? This is the ccna voice lab book, step 6, for anyone that may have it. Needless to say it did not receive any IP address out of the data vlan. I know I can just open the properties of the adapter and manually assign an address but I want to understand why its not working. I can post the output of the router and switch if needed.
