Hello,
Can anyone shed some light in the difference of show output command? My client thinks it is a Cisco bug. But I told him it is a default configuration when you create a L3 interface.
He stated like this as below:
switch shows strange behavior on displaying config when listing only displaying the running config from VLAN94, the line "no ip route-cache" is present:
Switch#sh run int vlan94
Building configuration...
Current configuration : 110 bytes
!
interface Vlan94
description MGMT_VL94
ip address 172.21.94.225 255.255.255.0
no ip route-cache
end
--------------------------------------
but when listing the whole running config the config line is missing:
-------------------------------------------------------
Switch#sh run
Building configuration...
Current configuration : 139889 bytes
!
......<omitted>
!
interface Vlan94
description MGMT_VL94
ip address 172.21.94.225 255.255.255.0
!
Can anyone who knows something about this provide an explanation? Appreciate the response.
