Disable the --more-- prompt in Cisco CLI

[IT_Joe]

**show startup-config**:

!
line con 0
login local
length 0
line vty 0
exec-timeout 0 0
login local
length 0
line vty 1 4
login local
length 0
line vty 5 15
login local
length 0
!

However I still get prompted with the --more-- on long outputs.
Is there a setting I'm missing?

[Joseph W. Doherty]

Possibly.

Cannot remember the exact command.  Something like terminal lines set to zero?

The correct command will stop the more pagination.

[Joseph W. Doherty]

Try

terminal length 0

[IT_Joe]

That's what I configured on the switch. 

I do not want to have to input this command every time I connect to the switch, but would prefer for this setting to be activated upon login (without typing).

[Joseph W. Doherty]

Ah, understand, I think.  Your OP could be read as you were not able to disable terminal pagination at all.  So, the issue is just for it to be the same across logins, correct?

[Joseph W. Doherty]

The couple of references (e.g.) if found, for making terminal length zero, proposes what you've already done, i.e. set length zero under console or vty settings.

You're doing this in a "real" Cisco device?  If so, what IOS is in running?

The only alternative that comes to mind is whether device might run some kind of connect/logon script, but not a feature I'm aware of.

[MHM Cisco World]

Can you more elaborate.

Thanks A Lot
MHM

[MHM Cisco World]

I dont get your Q well 
but 
you can use 
show run |  <<- after this you can include specific part of showing 

if you want to see all showing without --more-- 
only press TAB in keyword and the appear of showing is full all screen not appear as line by line 

Thanks A Lot
MHM