09-10-2021 11:42 AM
Hi everyone. Does someone know what is the meaning of "TD" code after the status "disabled" on show interface status?
This is the original output from switch:
#sh int status | i 3/0/2
Gi3/0/2 connected 120 a-full a-100 10/100/1000BaseTX
Gi3/0/20 connected 120 a-half a-100 10/100/1000BaseTX
Gi3/0/21 disabled: TD 120 auto auto 10/100/1000BaseTX
Thank you so much in advance for your help
09-10-2021 03:04 PM
Gustavo,
I'm not sure what that could be. However, could you share the outputs of the following commands please?
Thank you!
Best regards,
Peter
09-10-2021 03:12 PM
Gustavo,
It could in fact be an incomplete string from "disabled: TDR running". Is it possible that this interface is currently running the TDR test (from test cable diagnostics)?
Best regards,
Peter
09-10-2021 06:12 PM
The TDR function has crashed.
Re-run the TDR test, command: test cable tdr interface Gi3/0/21
If the problem does not fix itself, reboot stack member 3.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: