Dot1x Configuration in WS-C2960X-24TS-LL

[HarshavardhanP]

I have Configured the 802.1x Configuration in WS-C2960X-24TS-LL Switch Globally. when i test the aaa test it was successful. but when i tried to configure in the Interface the authentication was not happening. so can you please help to configure the 802.1x configuration in one of the Interface

[HarshavardhanP]

debug radius
Radius protocol debugging is on
Radius protocol brief debugging is off
Radius protocol verbose debugging is off
Radius packet hex dump debugging is off
Radius packet protocol debugging is on
Radius elog debugging debugging is off
Radius packet retransmission debugging is off
Radius table debugging is on
Radius server fail-over debugging is off
BC3-Test-SW1#debug dot1x all
All Dot1x debugging is on

[HarshavardhanP]

BC3-Test-SW1#debug radius
Radius protocol debugging is on
Radius protocol brief debugging is off
Radius protocol verbose debugging is off
Radius packet hex dump debugging is off
Radius packet protocol debugging is on
Radius elog debugging debugging is off
Radius packet retransmission debugging is off
Radius table debugging is on
Radius server fail-over debugging is off
BC3-Test-SW1#
BC3-Test-SW1#debug dot1x all
All Dot1x debugging is on
BC3-Test-SW1#

[MHM Cisco World]

BC3-Test-SW1#debug radius <<- without any keyword 
Radius protocol debugging is on <<- this  will be enable
Radius protocol brief debugging is off
Radius protocol verbose debugging is off
Radius packet hex dump debugging is off
Radius packet protocol debugging is on <<- this  will be enable
Radius elog debugging debugging is off
Radius packet retransmission debugging is off
Radius table debugging is on <<- this  will be enable
Radius server fail-over debugging is off

above is enough did you get any debug ?

BC3-Test-SW1#debug dot1x all <<- this must give use some detail about dot1x SW exchange with endpoint if endpoint is enable dot1x
All Dot1x debugging is on

MHM