08-29-2011 09:42 PM - edited 03-07-2019 01:58 AM
Hi Guys,
I am not able to find a command (dot1x host-mode multi-host) on the interface. any idea, why is the switch not supporting it ? and how to make it available on the switch ?
Switch "show ver" output -
Cisco IOS Software, C3750E Software (C3750E-UNIVERSAL-M), Version 12.2(52)SE, RELEASE SOFTWARE
Copyright (c) 1986-2009 by Cisco Systems, Inc.
Compiled Fri 25-Sep-09 01:39 by sasyamal
Image text-base: 0x00003000, data-base: 0x02400000
ROM: Bootstrap program is C3750E boot loader
BOOTLDR: C3750E Boot Loader (C3750E-HBOOT-M) Version 12.2(44r)SE3, RELEASE SOFTWARE (fc3)
Thanks
08-30-2011 01:33 AM
Hi,
Will you please post the output of "show dot1x interface ..." command.
Thanks & Regards,
Antonin
08-30-2011 01:39 AM
Hi Ami,
SW-02(config-if)#dot1x ?
credentials Credentials profile configuration
default Configure Dot1x with default values for this port
max-reauth-req Max No.of Reauthentication Attempts
max-req Max No.of Retries
max-start Max No. of EAPOL-Start requests
pae Set 802.1x interface pae type
supplicant Configure supplicant parameters
timeout Various Timeouts
SW-02#sh dot1x all
Sysauthcontrol Enabled
Dot1x Protocol Version 2
Dot1x Info for GigabitEthernet1/0/14
-----------------------------------
PAE = AUTHENTICATOR
PortControl = AUTO
ControlDirection = Both
HostMode = SINGLE_HOST
QuietPeriod = 60
ServerTimeout = 0
SuppTimeout = 30
ReAuthMax = 2
MaxReq = 2
TxPeriod = 30
08-30-2011 01:52 AM
Hi,
Since 12.2(50)SE IOS Authentication Manager CLI commands substitute some earlier 802.1x commands. Will you please try the command "authentication host-mode multi-host" instead. For more details plese see the link beneath (relevant to your IOS version):
Best regards,
Antonin
08-30-2011 03:41 AM
Thanks Ami....worked...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide