Doubts about SLM248G - 48-port 10/100

[ciscolover]

Hi all,

I have a SLM248G and i have 2 doubts.

How i can enable the telnet access on this switch? I only can administer him with http...

I think all the ports have LACP enable. This its true?

Regards.

[ranraju]

Hello,

Did you try configuring a password on the "line vty 0 15" and also give the command "transport input telnet" under the line vty....

With this configuraiton you should be able to telnet into the switch using the IP address thats configured on one of its SVIs.

Hope this helps.

Regards,

ranraju

[ciscolover]

The switch not have console and in the http interface i cannot configure vty lines...