Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all ¡¡
I have a virtual environment mounted with Gns3.
I have an environment of several L3 switches 3600 Software (C3640-IK9O3S-M), Version 12.4(25b) connected to area 0 OSPF.
Specifically, a switch connects through 2 different networks to area 0...
Hi all,
I have an IPSEC tunnel created. I Would like to limit the encapsulated traffic.
If I open all the network 1.1.1.0/24 in the ACL applyed the connection to the 445 port of the server 1.1.1.2 works well. But if I open only this traffic it ...
Hi all, I have an IPSEC tunnel created. I have some doubts about encryption and authentication of phase 1 and phase 2. With show crypto isakmp policy 10 I can see:Encryption algoritm DESHas MD5Authentication Method Preshared KEY.I think this is phas...
Hi all,
I have 2 doubts:
1)About NAT-T:
I have create an IP SEC tunnel like this (look at the diagram). http://www.cisco.com/c/en/us/support/docs/routers/1700-series-modular-access-routers/71462-rtr-l2l-ipsec-split.html
Is an easy tunnel but there...
Hi all,
I have 1 IPSEC VPN between Router B and Router C (blue LINE). I pass traffic between network 192.168.2.0 and 192.168.0.0.
Now I want to create another VPN between router A and B (red LINE) and I want to pass traffic between network 192.168.1...
Thank you very much for your help. We could say that when learning the same network, through the same neighbor and through the same network and priority, it only adds it once. And if one of those neighbors did not announce it, will learn it from the ...
I knew that it was not so easy to determine why one route was preferred over the other XD. Both networks are /24. Sorry but I don't understand if you need me to get some more command to see some missing data.
