07-27-2012 08:43 PM - edited 03-07-2019 08:01 AM
Hello, on a 2960 switch, is the default switchport mode 'dynamic desirable' ?
How can I see what the swtichport mode is. When I do a 'show run' nothing regarding switchport modes is visible ?
Thanks for any help.
07-27-2012 11:45 PM
Hi,
Yes, it's the default switch port setting. Cisco device IOSs normally don't display the default setting/command in the show run.
Issue a 'show interface x/x switchport' command to verify on which mode it's in.
Sent from Cisco Technical Support iPhone App
07-28-2012 09:16 AM
hi, you can use show int status this is shows all interfaces status
07-28-2012 10:18 AM
Hi Philip,
John is correct.
sh interfaces switchport brief
It will show an output like the below
Port Status Op.Mode Op.Encap Channel-id Vlan
Te1/1 connected trunk 802.1q -- 201,207
Te1/2 connected trunk 802.1q -- 201,207
Te1/3 disabled none native -- 201
Gi2/1 notconnect none native -- 201
Gi2/2 notconnect none native -- 201
Gi2/3 connected access native -- 201
Please do rate if the given information helps.
By
Karthik
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide