10-24-2013 08:03 AM - edited 03-07-2019 04:13 PM
Can someone please tell me how to edit the excluded address range in an existing DHCP scope? There's a present start and end range for addresses to exclude, I would like to edit that range. Please advise. Thank you.
Solved! Go to Solution.
10-24-2013 08:28 AM
Hi,
it must be done before configuring the pool so you'll have to do it all again from scratch because editing the excluded range won't have any effect on an existing pool.
Regards
Alain
Don't forget to rate helpful posts.
10-24-2013 08:28 AM
Hi,
it must be done before configuring the pool so you'll have to do it all again from scratch because editing the excluded range won't have any effect on an existing pool.
Regards
Alain
Don't forget to rate helpful posts.
10-24-2013 08:34 AM
Thank you. So, I'm going to have to delete the pool and recreate it from scratch?
10-24-2013 09:32 AM
Hi,
yes you'll have to do that after editing the excluded list.
Regards
Alain
Don't forget to rate helpful posts.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide