Just porting some EEM-stuff from Nexus 5500/5600 to 9300 - seems to be impossible, or am I just blind?
(config-applet)# action 20 ?
cli Configure a VSH CLI action
collect Collect debugging info using a yaml file
counter Specify the name of the counter
eem Event Manager command
event-default Do default action for the event
forceshut Force the entire switch to shut down
overbudgetshut Shut down the specified LCs due to power over budget
policy-default Do default action(s) of the policy being overridden
reload Reload the system or a specific module
snmp-trap Send out an SNMP trap
syslog Generate a syslog message
According to the documentation (https://www.cisco.com/c/en/us/td/docs/dcn/nx-os/nexus9000/102x/configuration/system-management/cisco-nexus-9000-series-nx-os-system-management-configuration-guide-102x.pdf) this seems to work as designed.
...at the EOS device it shows:
(config-applet)# action 20 ?
add Add
append Append to a variable
break Break out of a conditional loop
cli Configure a VSH CLI action
comment Add comment
continue Continue to next loop iteration
counter Specify the name of the counter
decrement Decrement a variable
divide Divide
eem Event Manager command
else Else conditional
elseif Elseif conditional
end End conditional block
event-default Do default action for the event
exit Exit from applet run
file File operation
foreach Foreach loop
if If conditional
increment Increment a variable
multiply Multiply
policy-default Do default action(s) of the policy being overridden
publish-event Publish an application specific event
puts Print data to active tty
regexp Regular expression match
reload Reload the system or a specific module
set Set a variable
snmp-trap Send out an SNMP trap
string String commands
subtract Subtract
syslog Generate a syslog message
wait Wait for a specified amount of time
while While loop
I didn't find any roadmap information, does anybody know better?